Ammonium Molybdate is an analytical reagent in a 100 gm pack, supplied with an MSDS, for detecting phosphate in biology and chemistry practicals. Added to an acidified sample and warmed, it gives a canary-yellow precipitate when phosphate is present, so classes can test bone ash, plant ash, soil or fertiliser samples for phosphorus.
| Parameter | Detail |
|---|---|
| Product | Ammonium Molybdate |
| Grade | Analytical reagent |
| Pack capacity | 100 gm |
| Safety documentation | Supplied with MSDS (Material Safety Data Sheet) |
| Product code | SCL367/085 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Supplied by | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Phosphate in bone and plant ash. Heat a small piece of dry bone or some dried leaves in a crucible with lid until only pale ash remains, and let it cool. Dissolve part of the ash in dilute nitric acid that staff have prepared from concentrated nitric acid, then filter the solution into a clean test tube.
Running the test. Add an excess of ammonium molybdate solution, made up in distilled water shortly before the class, and warm the tube gently over a spirit lamp, holding it in a test tube holder. A canary-yellow precipitate confirms phosphate, while a tube that stays clear shows none was detected.
Controls and comparisons. Run a positive control with a little calcium phosphate dissolved in the same acid, and a blank of acid and distilled water only. Students then test soil and fertiliser extracts and rank them by how quickly and how heavily the yellow precipitate forms.
Read the MSDS before the class. Wear gloves and goggles, above all once nitric acid is in use, and leave the concentrated acid to staff. Weigh the reagent on a digital analytical balance, keep the container tightly closed in a cool, dry place, and collect used test solutions in a labelled waste container.
The yellow phosphomolybdate forms only in acid solution, where the phosphate is present as phosphoric acid. In neutral or alkaline conditions no precipitate appears, even when phosphate is there. Nitric acid also dissolves the calcium phosphate in bone ash, bringing the phosphate into solution for the test.
It is ammonium phosphomolybdate, a yellow salt that is insoluble in the acid mixture, so its appearance shows that phosphate was in the sample. It can form slowly in the cold, which is why the tube is warmed. A faint yellow tint with no solid is not a clear result, so compare it with the controls.
Reducing substances in a sample, such as vitamin C in fresh plant juice or traces of organic matter, can reduce molybdate to an intense blue compound, and phosphate speeds this up. The blue colour is used in colorimetric phosphate methods, but the school test expects the yellow precipitate. Ashing samples first burns off the reducing matter.
Yes. Arsenate forms a very similar yellow precipitate with acidified molybdate, especially on warming, and a few other ions can interfere. School samples such as bone, leaves and fertiliser rarely contain them, but the result is most reliable when read beside a known phosphate control.
The positive control shows that the reagent and the warming step work. The blank of acid and distilled water shows the glassware and water are free of phosphate, since traces of phosphate detergent left in a tube can give a misleading yellow result. Only then can students draw a firm conclusion about each unknown.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 15 November 2026