Copper passes heat quickly, so this vessel and the liquid inside it reach a common temperature fast. The copper calorimeter is 100 mm long and 65 mm in diameter, with parallel sides and a rolled rim, which leaves room for a thermometer, a stirrer and a solid sample at once. Physics labs use it for cooling, specific heat and latent heat work. No stirrer is included.
| Parameter | Detail |
|---|---|
| Material | Copper |
| Shape | Parallel sides, rolled rim |
| Length | 100 mm |
| Diameter | 65 mm |
| Stirrer | Without stirrer |
| Product code | SLE/PHY/144 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Manufacturer | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Newton's law of cooling. Fill the vessel with hot water, stand it on an insulating base, and read a digital pocket thermometer every half minute against a digital stopclock. Plot temperature against time. The curve is steep at the start and flattens as the water nears room temperature. The apparatus for Newton's cooling law gives a dedicated set-up for the same study.
Specific heat of a liquid by cooling. Weigh the empty vessel, then weigh it again filled to the same level, first with water and then with the test liquid. Heat each to the same starting temperature and time it through the same fall in temperature. The vessel, its surface and the room stay unchanged, so at each temperature both lose heat at the same rate. Equating the heat lost per second in the two runs gives the specific heat of the liquid.
Latent heat of vaporisation. Weigh the vessel with cold water in it. Pass steam from a boiling flask through a steam trap so that only dry steam bubbles into the water. Stop when the water has warmed by several degrees, then weigh again to find the mass of steam condensed. The heat released as that steam condenses and cools equals the heat taken up by the water and the copper.
Copper is a good conductor, so the vessel quickly takes up the same temperature as its contents. Its specific heat is low, so for its mass it absorbs only a small part of the heat being measured. It does not react with water and can be formed into a thin vessel.
A bright, polished surface is a poor emitter of thermal radiation, so less heat leaves the vessel that way. A dull or tarnished surface radiates more and makes the readings less reliable. Polish lightly with a soft cloth and dry the vessel after use to slow tarnishing.
It is the mass of water that would take up the same heat as the vessel for each degree of temperature rise. Multiply the mass of the copper vessel by the specific heat of copper, then divide by the specific heat of water. Adding it to the water mass keeps the heat balance simple.
Water and the oils used in school practicals are fine. Strong acids and ammonia solutions can attack copper, which changes the mass of the vessel and spoils the result, so use a glass or other suitable vessel for them. Rinse and dry the copper straight after each run.
The rate at which the water loses heat depends on how much hotter it is than the room. At the start the difference is large and the temperature falls quickly. As the water approaches room temperature the difference shrinks, so the fall slows and the curve levels off.
Droplets of water carried with the steam have already given up their latent heat. If they reach the vessel, they add to the mass condensed without delivering that heat, so the latent heat works out too low. A steam trap in the delivery tube catches the droplets first.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 14 November 2026