Ten equal 10 g pieces make up the Mass Set, Brass, 100g, the lightest set in the small form slotted brass range. A 10 g hanger carries nine 10 g slotted masses, so soft springs, rubber bands and metre-rule levers can be loaded gently from 10 g to 100 g without overloading them.
| Parameter | Detail |
|---|---|
| Type | Small form slotted mass and hanger set |
| Material | Brass |
| Total mass | 100g, hanger included |
| Hanger | 1 x 10g (included) |
| Slotted masses | 9 x 10g |
| Smallest step | 10g |
| Product code | SLE/LB/31 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Manufacturer | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Law of moments on a metre rule. Balance the rule on a knife-edge clamp from the fulcrum and lever set. Hang the brass hanger with a few masses on one side and a known load on the other, slide them until the rule rests level, and compare load times distance on each side.
Mass of a small object by moments. Tie the object with cotton thread near one end of the balanced rule and hang a chosen number of 10 g masses on the other side. Move the loads until the rule is level, then equate the moments to find the unknown mass.
Rubber band against spring. Hang a rubber band and a soft spring side by side from a retort stand, load each in 10 g steps and then unload. The spring returns along the same line, while the band stretches unevenly and comes back by a different path.
The hanger is one of the ten pieces and weighs the same as each slotted mass. Leaving it out makes every load 10 g too small, which shifts a moments calculation or an extension graph by a whole step.
Balance the rule, hang the unknown on one side and the loaded hanger on the other, and move them until the rule is level. Multiply the known mass by its distance from the pivot, then divide by the distance of the unknown.
A thick or heavy thread adds mass that the calculation leaves out. With loads as small as 10 g, use thin cotton thread or a light wire loop, and make the loops alike on both sides of the pivot.
Balancing the empty rule first puts its centre of gravity over the pivot, so the rule's own weight adds no moment to either side. Use a sharp knife edge, note the balance point if it is not exactly at the centre mark, and take every reading with the loaded rule level.
Count the hanger and all nine masses into a tray at the start and end of each lesson. Handle the pieces by their edges, keep them off wet benches and wipe them with a dry cloth before stacking them back on the hanger.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 14 November 2026