The Slotted Mass Hanger, 500g gives a half-kilogram starting load for springs, pulley cords and wires before large slotted masses are added. It is a large format cast hanger. It comes as the hanger alone, so the masses that stack on it are bought separately.
| Parameter | Detail |
|---|---|
| Type | Large format slotted mass hanger (cast masses range) |
| Nominal hanger mass | 500g (0.5 kg) |
| Supplied as | Hanger only (slotted masses not included) |
| Product code | SLE/LB/29 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Manufacturer | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Mechanical advantage of a pulley block. Hang the 500g hanger from the lower block of a pulley demonstration set as the load, and pull on the effort string through a spring balance so the load rises slowly and steadily. Measure how far the effort and the load move, then repeat with slotted masses added to the hanger.
Atwood's machine. Clamp a rod-mounted pulley high on a retort stand and hang two 500g hangers from the ends of a light cord. Add a small slotted mass to one side, time its fall over a measured height, and compare the acceleration with the value predicted from the difference and the sum of the two masses.
Stiff springs. On a Hooke's law apparatus, use the hanger as the first load on a stiff steel extension spring, then add masses one at a time and read the pointer at eye level. Remove them in reverse order and check that the pointer comes back to its starting mark.
Two equal hangers balance each other, so only the small extra mass drives the motion while both hangers still have to be speeded up. The acceleration is then slow enough to time by hand. Check first that the two hangers balance with no extra mass on either side.
Mechanical advantage is the load divided by the effort needed to raise it steadily. Velocity ratio is the distance the effort moves divided by the distance the load rises in the same time. For a simple pulley block it equals the number of rope sections holding up the lower block.
Some of the work put in is lost to friction at the axles and in the rope, and some goes into lifting the lower pulley block itself. The mechanical advantage therefore always falls short of the velocity ratio, and efficiency, which is their ratio, is always less than one.
The weight of the moving block and the friction in the pulleys are roughly fixed. With a light load they take a large share of the effort, while with a heavier load they become a smaller part of it. Students should see efficiency climb, then level off, as the load grows.
Use it when the first load step must be smaller: on stiffer springs that a 1kg start would overstretch, in Atwood's machine where both sides need equal hangers, or as a counterweight in pulley demonstrations. A 1kg hanger suits work that runs in whole-kilogram steps.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 15 November 2026