This conical flask is a graduated Erlenmeyer flask in borosilicate glass, with a wide flat base that narrows to a slim neck. The sloping walls let a student swirl a solution without it splashing out, which is why this flask sits under the burette in most titrations. The glass is heat resistant and chemical resistant, and ten sizes run from 10 ml to 5000 ml.
| Parameter | Detail |
|---|---|
| Material | Borosilicate glass |
| Shape | Erlenmeyer (conical), wide flat base tapering to a narrow neck |
| Capacities | 10 ml, 25 ml, 50 ml, 100 ml, 250 ml, 500 ml, 1000 ml, 2000 ml, 4000 ml, 5000 ml |
| Marking | Graduated |
| Heat resistance | Heat resistant |
| Chemical resistance | Chemical resistant |
| Application | General chemical laboratory work |
| Product code | SLE/GFL/01 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Manufacturer | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Acid-alkali titration. Transfer a measured volume of alkali into the flask with a pipette and a pipette filler, then add two or three drops of phenolphthalein solution. Run acid in from a clamped burette while swirling the flask with one hand. Slow to single drops as the pink colour starts to fade, and stop at the first permanent change.
Dissolving and warming. Tip a weighed solid into the flask, add water and swirl until it dissolves. If gentle heat is needed, stand the flask on a wire gauze with ceramic centre over a burner and warm it slowly. Lift it off with flask tongs rather than by hand.
Collecting filtrate. Seat a glass funnel lined with folded filter paper in the neck. The narrow neck holds the funnel upright and the wide base keeps the flask steady while the filtrate runs in. Leave a small gap at the neck, for example with a folded strip of paper, so that air can escape and filtration does not stall.
No. They give only a rough idea of volume, useful for filling to about the right level. When the volume matters, measure it with a pipette, burette or measuring cylinder and use the flask as the container.
The sloping walls turn liquid back into the flask when it is swirled, so nothing is lost over the rim. A beaker has straight sides and a wide top, so a vigorous swirl can splash out some of the solution and spoil the titre.
Not if the water is distilled. The pipette delivers a fixed amount of alkali, and extra water does not change that amount, only its concentration. Rinse the flask with distilled water between runs, but never with the solution being titrated, which would add extra moles.
A white surface under the flask makes a faint change in indicator colour easy to see. That helps the student stop at the first lasting colour change instead of overshooting the end point by several drops.
Yes, the borosilicate glass is heat resistant, but heat it gradually on a wire gauze or hot plate. Never heat it empty or with a stopper in the neck, since trapped vapour builds pressure. Let a hot flask cool before it touches a cold or wet bench, to avoid thermal shock.
Fill it no more than about half full for swirling or heating, so the liquid stays well below the neck. An overfilled flask spills when swirled and can boil over when heated. Choose a larger size rather than filling a small one to the neck.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 14 November 2026