Kidneys And Blood Filtration kit lets students build model kidneys from dialysis tubing and filter simulated blood through them. Each group fills a tube from the 100 mL bottle of simulated unfiltered blood, stands it in a cup of water and chemically tests the filtrate for wastes removed, then links the result to the work of the nephrons.
| Parameter | Detail |
|---|---|
| Topic | The kidney in blood filtration and waste removal; tasks performed by nephrons |
| Activities | Create an artificial kidney model; filter simulated blood; chemically test the filtrate for possible wastes removed |
| Simulated unfiltered blood | 1 bottle, 100 mL (simulated, not real blood) |
| Dialysis tubing | 15 pieces |
| Plastic cups | 15 |
| Pipettes | 15, each 1 mL |
| Test reagents | Not named in the contents list |
| Product code | SLE/EB/10 |
| Minimum order | 10 units |
| Dispatch | Usually within 7 to 10 working days |
| Supplied by | ScienceLab (Jain Scientific Equipments Pvt Ltd), Ambala, India |
Building the model kidney. Soak a piece of dialysis tubing in water until it softens, then rub one end between finger and thumb to open it. Close the bottom with a tight knot or a tubing clip, add simulated blood with a 1 mL pipette and close the top. Rinse the outside under running water and stand the tube in a plastic cup of water so the filled part is covered.
Testing the filtrate. After a set time, lift the tube out and test the water in the cup with the chemical tests chosen for the practical. Students record which substances have crossed the membrane and which have stayed behind. A cup of plain water tested in the same way acts as the control.
Comparing with a real kidney. Students match their model against a kidney, nephron and glomerulus model set: the tubing wall stands for the filter in the glomerulus, and the cup water for the fluid entering the nephron. They then list what the model leaves out, such as blood pressure driving filtration and the reabsorption of useful substances along the tubule.
Size test with starch and glucose. As an extension, fill a length of Visking tubing with a mixture of starch and glucose solutions and stand it in water. Later, test the water with glucose test strips and a drop of iodine solution. Glucose turns up outside while starch stays inside, showing in its simplest form that particle size decides what crosses.
Dialysis tubing is a partially permeable membrane with very fine pores. Water, salts and small molecules such as urea and glucose fit through them, while large molecules such as proteins are too big. The tubing sorts particles by size alone, with no choice about which ones are useful.
Start by looking. If the simulated blood is coloured and the cup water stays clear, the large coloured parts were held back. Then run chemical tests on the cup water to find which smaller substances crossed, and compare the result with the plain-water control.
The tubing only lets particles diffuse from high to low concentration. With no living cells and no energy supply, it cannot carry out active transport. A real nephron filters the blood first, then actively takes glucose and many salts back into the blood, and much of the water follows by osmosis.
Parts of the simulated blood that stand for cells and proteins cannot cross an intact membrane, so finding them in the cup usually means a leak. Check the knots or clips, look for a split in the tubing, and make sure nothing ran down the outside while the tube was filled.
Dry tubing is stiff and flat, and its two sides cling together. Soaking it in water makes it soft and flexible, so the end can be opened by rubbing it between finger and thumb and the tube can be knotted without splitting.
To request a quotation, send the product name, code and quantity through our contact page or add the item to your enquiry cart.
Last updated: 15 November 2026