Parafilm (Product Code: SLE/CH/215) is a two-way stretch sealing film used to close the mouths of flasks, test tubes, beakers and dishes when a stopper or lid is not practical. Pulled gently in both directions, it clings around irregular shapes and surfaces and forms a snug seal against evaporation and dust. The film is 100mm wide and 38m long, free from plasticisers and non-toxic, which makes it a routine item among lab consumables in chemistry, biology and microbiology labs at schools, colleges and research institutes. It is supplied by Jain Scientific Equipments Pvt Ltd (ScienceLab), Ambala, India.
| Parameter | Detail |
|---|---|
| Type | Two-way stretch sealing film |
| Width | 100mm |
| Length | 38m |
| Stretch | Up to 200% |
| Melting temperature | 60°C |
| Composition notes | Free from plasticisers; non-toxic |
| Chemical resistance | Resists polar substances such as saline solutions, inorganic acid and alkaline solutions for up to 48 hours; resistant to most lower alcohols |
| Not suitable with | Many common solvents, such as diethyl ether and carbon tetrachloride, in which it is unstable |
| Handling | Clings around irregular shapes and surfaces |
Technicians use the film to cover conical flasks holding prepared solutions or broth, to seal test tubes before they are shaken, to wrap the rim of culture plates during incubation, and to close a measuring cylinder so it can be inverted for mixing. In microbiology lab work it is also used to keep plates and small containers from drying out while they are stored. Because it stretches up to 200%, a small square is usually enough for a flask neck, which keeps usage economical.
Cut a piece a little larger than the opening, stretch it across, then wrap and press it down the sides so it grips. Keep it away from heat: with a melting temperature of 60°C it is not for hot plates, ovens or autoclaves. Its resistance to salt, acid and alkaline solutions is rated for up to 48 hours, so for longer storage switch to a proper stopper or cap, and never rely on it with diethyl ether, carbon tetrachloride or similar solvents.
ScienceLab, the brand of Jain Scientific Equipments Private Limited in Ambala, Haryana, supplies this sealing film as a consumable rather than manufacturing it. Labs can add it to orders for the glassware and apparatus the company produces, which simplifies purchasing for a whole department. Learn more on our company profile.
Containers this film is most often stretched over:
More bench essentials are listed under Chemistry Lab Equipment.
What width and length of film is supplied?
The film is 100mm wide and 38m long.
Can it be used on containers holding organic solvents?
Only with care. It resists most lower alcohols, but it is unstable in many common solvents such as diethyl ether and carbon tetrachloride, so use a glass stopper or screw cap for those.
Can sealed containers be heated or autoclaved?
No. The film melts at 60°C, so remove it before any heating or sterilisation step.
How long will it hold against acids, alkalis and salt solutions?
It is resistant to saline, inorganic acid and alkaline solutions for up to 48 hours. For longer storage, a permanent closure is recommended.
Does it contain plasticisers?
No. It is free from plasticisers and non-toxic.
Can you supply it in quantity to a department or distributor?
Yes. ScienceLab supplies institutions and trade buyers in India and international markets. Send the product code SLE/CH/215 and the quantity through the contact page for a quotation.
Ask for pricing on Parafilm through our contact page, or add it to the enquiry cart together with the flasks and dishes you are ordering.
Last updated: 24 September 2026